The Antminer Z15 can be reset to factory settings using one of the methods listed below. Within ten minutes of the miner’s launch, this technique can be used. After the miner is turned on for 2 minutes, please press and hold the “Reset” button for 5 seconds, and then release it.
Table of Contents
How to Reset Miner to Factory Settings?
There are three ways to reset to Antminer Z15 factory settings:
1. Restore Via “Reset” Button
When the miner boots, this method can be used within ten minutes.
After powering on the miner for 2 minutes, please press “Reset” button for 5 seconds, then release it. Within 4 minutes, the miner will automatically restart and return to its factory settings, so there is no need to turn it off.
2. Restore Via Web Side
Log in to your miner user interface, click “Upgrade” > >”Perform reset”, then click “OK” on the pop up window.
Log in to your Antminer Z15 miner user interface,Click “Restore factory settings” in the lower right corner and select “Restore factory settings” in the pop-up selection box, then wait for a reboot.
3. Restore Via “IP Report” Button
Turn off the Antminer Z15 miner, then keep holding down the IP Reporter while not letting go. Power on the mine once more at the same time. After 5 seconds, the machine will automatically return to its factory default settings after being released from the IP Reporter.
The miner that has an SD card next to the Ethernet interface is ineligible for use with this technique.
The Antminer Z15 miner will be in its original firmware after being reset. updated Antminer Z15 firmware should be loaded into the miner.
How to Restart Antminer Z15
1. Reset recovery (can only be reset within 2 minutes to 10 minutes after the miner was powered on, otherwise it is failed, applicable to all Antminer models except G1 and G2)
After shutdown and restart for 2 minutes, press and hold the “Reset” button for 5 seconds, then release, the miner will restore factory settings within 4 minutes and restart automatically (no need to shutdown the miner).
2. Use website recovery in the background of the interface
Computer or mobile phone tablet, use the browser to enter the IP address of the mining machine, log in to the account root, password root, (Apple users please pay attention to the input method to reduce space)
Click Upgrade —> perform a reset, click “OK” in the pop-up dialog box
Antminer Z15 Overview
The Bitmain Antminer Z15 is a Zcash miner. It mines the Equihash algorithm, with a maximum hashrate of 420 kh/s and a power consumption of 1510 W.
At an electricity cost of 8¢ /kwH, the Bitmain Antminer Z15 profitability is $-0.55 every 24 hours. The amount mined per day is 0.0527 ZEC.
